Dollar Days + Demo Derby & $800 to win G&G Express Sport Mods

REAR WHEEL DRIVE

1. All judge’s rulings are final. 1980 or newer cars. Pre ran cars ok. If running a pre ran doesn’t mean you can crease, tuck or weld on anything. We can tell the difference.

2. No cross breeding. Entire drive line must be same as car. (Chevy to Chevy, Ford to Ford). Must be factory engine. Pipes through hood are permitted.

3. Drivers door may welded. All other doors must be chained or wired. No more than 6 places.

4. Trunks must be chained or wired. No more than 6 places. TRUNKS MUST BE OPEN DURING INSPECTION! No welding or adding metal. Notching frame is ok.

5. Hoods may be bolted in 2 places sheet metal to sheet metal. No all thread. May be wired or chained in 4 spots. 1⁄4” chain or 2 strands of wire per hole. It must be sheet metal to sheet metal only. No welding washers for holes. Must be 12” hole in hood in case of fire. Hood must be open for inspection. Remove hood latch.

6. Must use tires. Must be stock wheels. Any tire ok.

7. Gas tanks may be moved or left in stock position. Fuel cell preferred but stock tanks ok. Must be secured and does not move. No gas tank protectors!!! Gas tank holders can come off back bar. Protector not allowed to any part of interior.

8. Windshield can be removed. If removed must run 2 windshield bars. One in front of driver other in middle of cowl.

9. The following must be removed prior to entering grounds. Windows, headlights, tail lights, all chrome and mirrors. Interior must be swept clean of debris and glass.

10. Stock springs and shocks. No solid suspensions. 2 Spring risers ok. Wire chains or any weld on rear end spring pockets. Cars must bounce and be stock. Bottom of bumper heights. Car must sit no higher 21” from ground to bottom of bumper. No lower than 16” from ground to bottom of bumper.

11. 12” hole in hood in case of fire.

12. Car must look and be stock
13. Paint drivers door in orange or yellow.

14. Battery may be moved inside of car. 1 battery only. If moved it must be secured and covered. If left in stock you can spray foam around battery.

15. Welded rear ends ok. All cars came with gears and axles.
16. Bumpers can be welded on including bumper shocks. DEC flat type bumpers ok. No pointy bumpers. Hard nose ok.

17. Read rules carefully and follow them! This is a cheap and easy build. Any questions call! There will no starching or bending of rules. NO REFUNDS!!!!!

18. Once cars are inspected they will be put in an impound area. No one is allowed to touch car in impound area.

19. Bar behind seat is highly recommended. 4 point floating cage with rollover bar. Rollover bar can not touch roof. Use gussets to attach to back bar.